Removal And Installation

TRANSFER ASSEMBLY

VK50VE : Removal and Installation


REMOVAL

1.Remove transmission assembly from the vehicle. Removal And Installation.
2.Remove transfer air breather hose.
3.Remove rear engine mounting member and engine mounting insulator with power tool. Exploded View.
4.Support transfer assembly with a jack.
5.Remove transfer mounting bolts with power tool and separate transfer from transmission.

CAUTION:
Secure transfer assembly and transmission assembly to a jack.

INSTALLATION

Note the following, and install in the reverse order of removal.





- When installing the transfer to the transmission, install the mounting bolts following the standard below, tighten bolts to the specified torque.





- When installing transfer air breather hose, make sure there are no pinched or restricted areas on the transfer air breather hose caused by bending or winding.





- Set transfer air breather hose with the paint mark (A) facing upward.





- Be sure to insert air breather hose (1) of transmission side to air breather tube until hose end reaches the tube bend R portion.





- Be sure to insert air breather hose (1) of transfer side to air breather tube (2) until hose end reaches the tube bend R portion.





- Be sure to fix air breather hose in (A) parts of transmission and transfer.
- After the installation, check the fluid level, fluid leakage and the A/T
positions. Inspection.