For Mexico

P0524 ENGINE OIL PRESSURE

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC P0524 is displayed with DTC P0075 or P0081, perform trouble diagnosis for DTC P0075 or P0081
first. For Mexico.






DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING-I

1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:


Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle.
- GO TO 2.

2. PRECONDITIONING-II

Check oil level and oil pressure. Inspection.
Is the inspection result normal?
YES- GO TO 3.
NO- Proceed to Inspection.

3. PERFORM DTC CONFIRMATION PROCEDURE

WITH CONSULT
1.Select "DATA MONITOR" mode with CONSULT.
2.Maintain the following conditions for at least 20 consecutive seconds.






CAUTION:
Always drive at a safe speed.
3.Check 1st trip DTC.
WITH GST
Follow the procedure "With CONSULT" above.
Is 1st trip DTC detected?
YES- Proceed to
NO- INSPECTION END


Diagnosis Procedure


1. CHECK OIL PRESSURE WARNING LAMP

1.Start engine.





2.Check oil pressure warning lamp and confirm it is not illuminated.
Is oil pressure warning lamp illuminated?
YES- Proceed to Inspection.
NO- GO TO 2.

2. CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE

For Mexico.
Is the inspection result normal?
YES- GO TO 3.
NO- Replace malfunctioning intake valve timing control solenoid valve.

3. CHECK CRANKSHAFT POSITION SENSOR

For Mexico.
Is the inspection result normal?
YES- GO TO 4.
NO- Replace crankshaft position sensor.

4. CHECK CAMSHAFT POSITION SENSOR

For Mexico.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace malfunctioning camshaft position sensor.

5. CHECK CAMSHAFT SPROCKET (SIGNAL PLATE)

Check the following.





- Accumulation of debris to the signal plate of camshaft sprocket (INT)
- Chipping signal plate of camshaft sprocket (INT)
Is the inspection result normal?
YES- GO TO 6.
NO- Remove debris and clean the signal plate of camshaft sprocket (INT) or replace camshaft sprocket (INT).
Exploded View.

6. CHECK TIMING CHAIN INSTALLATION

Check service records for any recent repairs that may cause timing chain misaligned.
Are there any service records that may cause timing chain misaligned?
YES- Check timing chain installation. Exploded View.
NO- GO TO 7.

7. CHECK LUBRICATION CIRCUIT

Perform "Inspection of Camshaft Sprocket (INT) Oil Groove". Inspection.
Is the inspection result normal?
YES- GO TO 8.
NO- Clean lubrication line.

8. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END