Disassembly And Assembly

OUTSIDE MIRROR

DOOR MIRROR ASSEMBLY : Disassembly and Assembly


DISASSEMBLY

1.Remove door mirror assembly from front door panel. Removal And Installation.
2.Remove glass mirror. Glass Mirror.
3.Remove door mirror cover. Door Mirror Cover.
4.Remove actuator.





1.Remove actuator (1) fixing screws (A).
2.Disconnect the harness connectors behind the actuator.
NOTE:





Disconnect the harness connector (B) of automatic driving position system (2) if equipped.
5.Remove side camera finisher assembly (1).





1.Remove side camera finisher fixing screw (A).





2.Disconnect harness connector (B), and remove screws (C)
and pawl (D) fixing the side camera finisher (1) to housing.





3.Remove side turn signal lamp fixing screws (E), and then remove side turn signal lamp.
NOTE:
Pull slightly side camera finisher (1) covering side turn signal lamp bottom screw.
4.Remove side camera finisher assembly.
5.Remove around view camera. Service and Repair.
6.Remove all the harness connector terminal from the connector.
NOTE:
Write a short note to describe connector terminal layout before starting operation.
7.Remove base.





1.Remove base cover.
Remove base cover fixing pawls with a flat-bladed screwdriver (A) wrapped into a tape.

CAUTION:
Apply protective tape (B) around the base to protect the surface from damage.





2.Remove puddle lamp. Removal And Installation.
3.Remove base mounting bolts located under base cover.
4.Remove base.
8.Remove the fixing screws (A), and then remove power fold unit and bracket from housing.





9.Remove fixing screws (A), (B) and then remove power fold unit (2) from bracket (1).






ASSEMBLY

Assemble in the reverse order of disassembly.