Seats: Adjustments

SECOND SEAT

Adjustment


ADJUSTMENT

SEATBACK CONTROL WIRE
Adjust in accordance with the following procedures when installing the seatback control wire of the 2nd seat.
1.Tilt the seatback forward and set the seatback to the 1st lock position.





2.Install the seatback control wire (1) so that it is not slack.
3.Set the clearance of portion (A) to 2 mm (0.079 in) and tighten the bolt (B).
4.Operate the rear seat lever assembly and fold the seat.
5.Set the seat to the seating position and check that the seat locks.
SEAT CUSHION CONTROL WIRE





1.Align to hole and insert top end (A) of seatback frame side of seat cushion control wire (1).
2.Fit 2nd groove from the top end (B) of adjusting plastic part of seat cushion control wire (1) to the end of groove.
3.Lower the top end (A) of seat cushion control wire (1) to the lower end of hole.





4.Check branch portion (1) of seat cushion control wire for the following items.





- Check that ball (B) of wire top end is only visible from sponge portion (A).
- Pull plastic portion (C) and check that seat cushion control wire is not disconnected.

CAUTION:
Adjust again for the following status A or B as shown in the figure.
Status A





- The ball is not visible from sponge (A) portion. Adjust in accordance with the following procedures.





- Fit 3rd groove from the top end of adjusting plastic portion (A)


to the end of groove.
- Check that ball of wire or end is only visible from sponge portion in branch portion of seat cushion control wire.
Status B





- The wire (B) is visible from sponge (A) portion. Adjust in accordance with the following procedures.





- Fit 1st groove from the top end of adjusting portion (A) to the end of groove.


- Check that wire is not visible from sponge portion in branch portion of seat cushion control wire.