For Mexico

ICC BRAKE SWITCH

Component Function Check


1. CHECK ICC BRAKE SWITCH FUNCTION

WITH CONSULT
1.Turn ignition switch ON.
2.Select "BRAKE SW-1" in "DATA MONITOR" mode with CONSULT.
3.Check "BRAKE SW-1" indication under the following conditions.





WITHOUT CONSULT
1.Turn ignition switch ON.
2.Check the voltage between ECM harness connector terminals as per the following.





Is the inspection result normal?
YES- INSPECTION END
NO- Go to .


Diagnosis Procedure


1. CHECK DTC WITH ADAS CONTROL UNIT

ADAS Control Unit and Testing and Inspection.
Are any DTCs detected?
YES- Perform the Diagnosis Procedure corresponding to the detected DTC.
NO- GO TO 2.

2. CHECK OVERALL FUNCTION

WITH CONSULT
1.Turn ignition switch ON.
2.Select "BRAKE SW-1" in "DATA MONITOR" mode with CONSULT.
3.Check "BRAKE SW-1" indication under the following conditions.





WITHOUT CONSULT
1.Turn ignition switch ON.
2.Check the voltage between ECM harness connector terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 3.

3. CHECK ICC BRAKE SWITCH POWER SUPPLY CIRCUIT-I

1.Turn ignition switch OFF.
2.Disconnect ICC brake switch harness connector.
3.Turn ignition switch ON.
4.Check the voltage between ICC brake switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 7.
NO- GO TO 4.

4. CHECK ICC BRAKE SWITCH POWER SUPPLY CIRCUIT-II

Check the voltage between ICC brake switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 6.
NO- GO TO 5.

5. DETECT MALFUNCTIONING PART

Check the following.
- Fuse block (J/B) connector E103
- 10 A fuse (No. 3)
- Harness for open or short between ICC brake switch and fuse
- Repair open circuit or short to ground in harness or connectors.

6. CHECK ICC BRAKE SWITCH

.
Is the inspection result normal?
YES- GO TO 9.
NO- Replace ICC brake switch. Removal And Installation.

7. CHECK ICC BRAKE SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between ICC brake switch harness connector and ECM harness connector.





4.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 9.
NO- GO TO 8.

8. DETECT MALFUNCTIONING PART

Check the following.
- Harness for open or short between ICC brake switch and ECM
- Loose or poor connection for each connector and harness
- Repair open circuit, short to ground or short to power in harness or connectors.

9. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END


Component Inspection (ICC Brake Switch)


1. CHECK ICC BRAKE SWITCH-I

1.Turn ignition switch OFF.
2.Disconnect ICC brake switch harness connector.
3.Check the continuity between ICC brake switch terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 2.

2. CHECK ICC BRAKE SWITCH-II

1.Adjust ICC brake switch installation. Adjustments.
2.Check the continuity between ICC brake switch terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace ICC brake switch. Removal And Installation.