Tire Monitoring System: Service and Repair
ID REGISTRATION
Work Procedure
1. CONFIRMATION OF ACTIVATION TOOL USE
Check method of ID registration procedure.
Is the activation tool (J-45295) used for the tire pressure sensor ID registration procedure?
YES- GO TO 2.
NO- GO TO 3.
2. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITH THE ACTIVATION TOOL)
With CONSULT
1.Turn the ignition switch ON.
2.Display the "WORK SUPPORT" screen for "AIR PRESSURE MONITOR" and select "ID REGIST".
3.Press the activation tool (J-45295) (1) against the side of the tire at the location closest to the tire pressure sensor.
4.Wait until the indicator lamp turns OFF (approximately 5 seconds).
CAUTION:
Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
5.When ID registration is completed, check the following pattern at each wheel.
6.After the ID registration procedure for all wheels is completed, press "End" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES- ID registration END.
NO- Perform the self-diagnosis for "AIR PRESSURE MONITOR". Testing and Inspection.
3. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITHOUT THE ACTIVATION TOOL)
With CONSULT
1.Display the "WORK SUPPORT" screen for "AIR PRESSURE MONITOR" and select "ID REGIST".
2.Adjust the tire pressure for all wheels to match the list below.
3.Drive the vehicle at a speed at more than 40 km/h (25 MPH) for 3 minutes or more, then perform the tire pressure sensor ID registration procedure.
4.After ID registration for all wheels is completed, press "End" to end ID registration.
5.Adjust the tire pressures for all wheels to the specified value. [1][2]Specifications.
Is ID registrations for all wheels completed?
YES- ID registration END.
NO- Perform the self-diagnosis for "AIR PRESSURE MONITOR". Testing and Inspection.