C1199

C1199 VACUUM SENSOR

Description

The vacuum sensor converts the vacuum pressure to an electric signal and transmits it to the ABS actuator and electric unit (control unit).


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

1.Turn the ignition switch ON.
2.Perform self-diagnosis for "ABS" with CONSULT.
Is DTC "C1199" detected?
YES- Proceed to diagnosis procedure. Refer to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK BRAKE BOOSTER

Check brake booster. Refer to "Inspection" Inspection.
Is the inspection result normal?
YES- GO TO 2.
NO- Replace brake booster. Refer to "Exploded View" Exploded View.

2. CHECK CONNECTOR

1.Turn the ignition switch OFF.
2.Disconnect ABS actuator and electric unit (control unit) harness connector.
3.Disconnect vacuum sensor harness connector.
4.Check terminal for deformation, disconnection, looseness, etc.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace error-detected parts.

3. CHECK VACUUM SENSOR HARNESS

Check the continuity between vacuum sensor harness connector and ABS actuator and electric unit harness connector.





Is the inspection result normal?
YES- Replace brake booster. Refer to "Exploded View" Exploded View.
NO- Repair or replace error-detected parts.


Special Repair Requirement


1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit). Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Description" Description.
- END