Sunroof / Moonroof: Adjustments

GLASS LID

Adjustment







LID WEATHER-STRIP OVERLAP ADJUSTMENT AND SURFACE MISMATCH ADJUSTMENT

1.Remove the side trim upper side, and then fold the side trim so that the TORX bolts can be seen.
2.After loosening glass lid from TORX bolts (left and right), tilt down glass lid.
3.Adjust glass lid from outside of vehicle so it resembles "A - A" "B - B" "C - C" as shown in the figure.





4.To prevent glass lid from moving after adjustment, first tighten the TORX bolts of front left, and then tighten the TORX bolts of rear right.
5.Tighten remaining TORX bolts, being careful to prevent glass lid from moving.
6.Tilt glass lid up and down several times to check that it moves smoothly.
NOTE:
After adjustment the sunroof unit assembly, perform additional service. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" Special Repair Requirement.