Procedures

DRIVE BELT

Checking


WARNING:
Be sure to perform the this step when engine is stopped.
- Check that the indicator (C) (notch on fixed side) of drive belt auto-tensioner is within the possible use range (A).
NOTE:
- Check the drive belt auto-tensioner indication when the engine is cold.
- When new drive belt is installed, the indicator (notch on fixed side) should be within the range (B) in the figure.
- Visually check the entire drive belt for wear, damage or crack.
- If the indicator (notch on fixed side) is out of the possible use range or belt is damaged, replace drive belt.