Tire Monitoring System: Service and Repair

ID REGISTRATION

Work Procedure


1. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE


CAUTION:
To perform ID registration, observe the following points:
- Never register ID in a place where radio waves are interfered (e.g. radio tower).
- Never register ID in a place close to vehicles including TPMS.
With CONSULT
1.Display the "WORK SUPPORT" screen and select "ID REGIST".
Is the tire pressure sensor activation tool (J-45295) used for the tire pressure sensor ID registration procedure?
YES- GO TO 2.
NO- GO TO 3.

2. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITH TIRE PRESSURE SENSOR ACTIVATION TOOL)
1.Turn the ignition switch ON.
2.Select the start button on the "ID REGIST" screen.

3.Contact the tire pressure sensor activation tool (J-45295) (1) to the side of the tire at the location to the tire pressure sensor.
4.Press and hold the tire pressure sensor activation tool button while pushing the tool to the tire surface. (approximately for 5
seconds)

CAUTION:
Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
5.When ID registration is completed, check the following pattern at each wheel.





6.After the ID registration procedure for all wheels is completed, press "END" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES- ID registration END.
NO- Refer to "Diagnosis Procedure5>.

3. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE (WITHOUT TIRE PRESSURE SENSOR

ACTIVATION TOOL)
1.Adjust the tire pressure for all wheels to match the list below.





2.Drive the vehicle at a speed at more than 40 km/h (25 MPH) for 3 minutes or more, then perform the tire pressure sensor ID registration procedure.
3.After ID registration for all wheels is completed, press "END" to end ID registration.





4.Adjust the tire pressures for all wheels to the specified value. Refer to "Tire Air Pressure" [1][2]Specifications.
Is ID registrations for all wheels completed?
YES- ID registration END.
NO- Performs trouble-diagnosis of the Tire Pressure Monitoring System (TPMS). Refer to "DTC Index" Testing and Inspection.