Door Mirror Motor

DOOR MIRROR MOTOR

Description

It makes mirror face operate from side to side and up and down with the electric power that AUTOMATIC
DRIVE POSITIONER CONTROL UNIT supplies.


Component Function Check


1. CHECK DOOR MIRROR MOTOR FUNCTION

Check the operation with "MIRROR MOTOR RH" and "MIRROR MOTOR LH" in "ACTIVE TEST" mode with
CONSULT
Refer to "CONSULT Function" CONSULT Function.
Is the inspection result normal?
YES- INSPECTION END
NO- Refer to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK DOOR MIRROR MOTOR INPUT SIGNAL

1.Turn ignition switch ON.
2.Check voltage between door mirror connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK HARNESS CONTINUITY

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit connector.
3.Check continuity between automatic drive positioner control unit connector and door mirror connector.
[Door mirror driver side]





[Door mirror passenger side]





4.Check continuity between automatic drive positioner control unit connector and ground.
[Door mirror driver side]





[Door mirror passenger side]





Is the inspection result normal?
YES- Replace automatic drive positioner control unit. Refer to "Removal and Installation" Removal and Installation.
NO- Repair or replace harness or connector.

3. CHECK DOOR MIRROR MOTOR

Check door mirror motor.
Refer to "Component Inspection" .
Is the inspection result normal?
YES- GO TO 4.
NO- Replace door mirror. Refer to "DOOR MIRROR ASSEMBLY : Removal and Installation" With ADP.

4. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END


Component Inspection


1. CHECK DOOR MIRROR MOTOR-I

Check that door mirror motor does not trap foreign objects and does not have any damage.
Refer to "Exploded View" With ADP.
Is the inspection result normal?
YES- GO TO 2.
NO- Replace door mirror. Refer to "DOOR MIRROR ASSEMBLY : Removal and Installation" With ADP.

2. CHECK DOOR MIRROR MOTOR-II

1.Turn ignition switch OFF.
2.Disconnect door mirror connector.
3.Apply 12V to each power supply terminal of door mirror motor.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace door mirror. Refer to "DOOR MIRROR ASSEMBLY : Removal and Installation" With ADP.