Intelligent Key

INTELLIGENT KEY

Description

The following functions are available when having and carrying electronic ID.
- Door lock/unlock
- Engine start
Remote control entry function and panic alarm function are available when operating on button.


Component Function Check


1. CHECK FUNCTION

Check remote keyless entry receiver ("RKE OPE COUN1") in Data Monitor mode with CONSULT.





Is the inspection result normal?
YES- Intelligent Key is OK.
NO- Refer to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK INTELLIGENT KEY BATTERY






Check by connecting a resistance (approximately 300ohms) so that the current value becomes about 10 mA.





Is the measurement value within the specification?
YES- Replace Intelligent Key.
NO- Replace Intelligent Key battery. Refer to "Component Inspection" .


Component Inspection


1. REPLACE INTELLIGENT KEY BATTERY

1.Release the lock knob at the back of the Intelligent Key and remove the mechanical key.





2.Insert a remover tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part.

CAUTION:
- Do not touch the circuit board or battery terminal.
- The key fob is water-resistant. However, if it does get wet, immediately wipe it dry.
3.Replace the battery with new one.





4.Align the tips of the upper and lower parts, and then push them together until it is securely closed.

CAUTION:
- When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.
- After replacing the battery, check that all Intelligent Key functions work normally.
Is the inspection result normal?
YES- Intelligent Key is OK.
NO- Check remote keyless entry receiver. Refer to "Component Function Check" Remote Keyless Entry Receiver.


Special Repair Requirement

Refer to CONSULT Operation Manual NATS-IVIS/NVIS.