Removal and Installation

HEADLINING

SUNROOF : Removal and Installation


REMOVAL

1.Remove rear seat cushion and seat back. Refer to "Removal and Installation" Removal and Installation.
2.Remove front seat belt anchor bolt (LH/RH). Refer to "SEAT BELT RETRACTOR : Exploded View" Exploded View.
3.Remove rear seat belt anchor bolt (LH/RH). Refer to "SEAT BELT RETRACTOR : Exploded View" Exploded View.
4.Remove luggage side lower finisher (LH/RH), luggage side upper finisher (LH/RH). Refer to "Removal and Installation" Removal and Installation.
5.Remove front pillar garnish (LH/RH), front kicking plate (LH/RH), center pillar lower garnish (LH/RH), center pillar upper garnish (LH/RH), front body side welt (LH/RH), rear body side welt (LH/RH), rear kicking plate (LH/RH). Refer to "Removal and Installation" Removal and Installation.





6.Disconnect roof harness connectors (A) and clips (B), then remove the roof harness.





7.Remove front roof finisher mounting pawls with remover tool (A), disconnect the harness connector and then remove front roof finisher (1).










8.Remove the front camera finisher (1) mounting pawls with a remover tool (A), then remove the front camera finisher.





9.Remove sun-visor (LH/RH).
- Remove sun-visor cap.
- Remove mounting screws.
- Disconnect vanity mirror lamp harness connector (With vanity mirror lamp)
10.Disconnect inside mirror harness connector.





11.Insert a small flatted-blade screwdriver (A) into the hole of the sun-visor holder (1), press while rotating approximately 90
degrees to remove.





12.With a small flatted-blade screwdriver (A), press the upper side mounting plastic clip (1) and pull up to remove the mounting plastic clip from assist grip (2).





13.Once the mounting plastic clip (1) is removed, pull out the assist grip (2) to remove.
14.Recline front seat back to facilitate the headlining removal.





15.Pull map lamp assembly toward and disengage metal clips (B)
and dual-lock fastener (A).

CAUTION:
Map lamp assembly is crimped from the back of headlining.
Remove it by disengaging the crimped area of back of map lamp assembly after removing headlining from the vehicle.
16.Using remover tool, remove headlining hidden clip at the back side of headlining.





17.Remove headlining (1) from back door.

CAUTION:
- When removing, 2 workers are required.
- Never bend headlining when removing.
- Be careful not to scratch or damage any part of the body while taking out the headlining.
18.Remove the following parts after removing headlining.
- Personal lamp. Refer to "Removal and Installation" Removal and Installation.
- Map lamp assembly. Refer to "Removal and Installation" Removal and Installation.
- Over-head console.
- Antenna feeder assembly. Refer to the following.
- Base audio without navigation. Refer to "Feeder Layout" Base Audio.
- Bose audio without navigation. Refer to "Feeder Layout" Without Navigation.
- Bose audio with navigation. Refer to "Feeder Layout" With Navigation.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- As for guide, install first sun-visor holder (LH/RH) and then the rear hidden clips at the back side of headlining.
- Be careful not to bend the headlining when installing.