Maintenance Indicator Reset

Engine oil replacement indicator:

This indicator appears when the set time comes for changing the engine oil.

You can set or reset the distance for changing the engine oil using the following procedure.





Switches for the trip computer are located on the right side of the combination meter panel. To operate the trip computer, push the switches shown above.

When the ignition switch is pushed to the ON position, modes of the trip computer can be selected by pushing switch A.





Each time switch A is pushed the display will change as shown above.

1. Push switch A to move to the warning check mode.
2. Push switch B to select other menus and select "MAINTENANCE".
There are 5 submenus under "MAINTENANCE".
3. Select "ENGINE OIL" to set or reset the distance for changing the engine oil.