B2617

B2617 STARTER RELAY CIRCUIT

Description

Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B2617 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"DTC Logic" Body Control System.
- If DTC B2617 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"DTC Logic" Body Control System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON under the following conditions and wait for at least 1 second.
-CVT selector lever is in the P (Park) position.
-Do not depress the brake pedal.
2.Check "Self-Diagnostic Result" with CONSULT.
Is DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" Engine Start Function.

1. CHECK STARTER RELAY

1.Turn ignition switch ON.
2.Check voltage between BCM harness connector and ground under the following condition.





Is the measurement value within the specification.
YES- GO TO 3.
NO- GO TO 2.

2. CHECK STARTER RELAY CIRCUIT

Revision: March 20122013 Infiniti JX
1.Turn ignition switch OFF.
2.Disconnect BCM harness connector and IPDM E/R harness connector.
3.Check continuity between IPDM E/R harness connector and BCM harness connector.





4.Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- Replace BCM. Refer to "Removal and Installation" Service and Repair.
NO- Repair harness or connector.

3. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- Inspection End.
Revision: March 20122013 Infiniti JX