C1608

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Turn the ignition switch OFF to ON.
2.Perform "EPS" self-diagnosis.
Is DTC "C1607" or "C1608" detected?
YES- Proceed to diagnosis procedure. Refer to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure


1. PERFORM SELF-DIAGNOSIS

With CONSULT
1.Turn the ignition switch OFF to ON.
2.Erase self-diagnostic results for "EPS".
3.Turn the ignition switch OFF and wait for at least 10 seconds.
4.Perform self-diagnosis for "EPS".
Is DTC "C1607" or "C1608" detected?
YES- Power steering control module is malfunctioning. Replace power steering oil pump assembly.
Refer to "Removal and Installation" Removal and Installation.
NO- Check pin terminal and connection of each harness connector for malfunctioning conditions.
Revision: March 20122013 Infiniti JX