P1557

P1556, P1557 BATTERY TEMPERATURE SENSOR

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:


Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Start the engine and let it idle at least 10 seconds.
2.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK BATTERY TEMPERATURE SENSOR INPUT SIGNAL

1.Disconnect battery current sensor harness connector.
2.Turn ignition switch ON.
3.Check the voltage between battery current sensor harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK BATTERY TEMPERATURE SENSOR INPUT SIGNAL CIRCUIT

1.Turn ignition switch ON.
2.Disconnect ECM harness connector.
Revision: March 20122013 Infiniti JX
3.Check the continuity between battery current sensor harness connector and ECM harness connector.





Is the inspection result normal?
YES- Perform the trouble diagnosis for power supply circuit.
NO- Repair or replace error-detected parts.

3. CHECK BATTERY TEMPERATURE SENSOR GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between battery current sensor harness connector and ECM harness connector.





4.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair open circuit, short to ground or short to power in harness or connectors.

4. CHECK BATTERY TEMPERATURE SENSOR

Check battery temperature sensor. Refer to "Component Inspection (Battery Temperature Sensor)" .
Is the inspection result normal?
YES- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- Replace battery negative cable assembly.


Component Inspection (Battery Temperature Sensor)


1. CHECK BATTERY TEMPERATURE SENSOR

1.Turn ignition switch OFF.
2.Disconnect battery current sensor.
3.Check the resistance between battery current sensor connector terminals.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace battery negative cable assembly.
Revision: March 20122013 Infiniti JX