RH

SPINDLE MOTOR

RH : Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" Electrical Diagrams.

1. CHECK SPINDLE MOTOR INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect spindle unit RH connector.
3.Check voltage between spindle unit RH harness connector and ground.





Is the inspection result normal?
YES- Replace spindle unit RH. Refer to "SPINDLE UNIT : Removal and Installation" Service and Repair.
NO- GO TO 2.

2. CHECK SPINDLE MOTOR CIRCUIT

1.Disconnect automatic back door control module connector.
2.Check continuity between automatic back door control module harness connector and spindle unit harness connector.





3.Check continuity between automatic back door control module harness connector and ground.





Is the inspection result normal?
YES- Replace automatic back door control module. Refer to "Removal and Installation" Service and Repair.
NO- Repair or replace harness.