Removal and Installation

SECOND ROW SEATS

Removal and Installation


LH BENCH SEAT

Removal

CAUTION:
- Before removal and installation, use shop cloths to protect parts from damage.
- During removal and installation, an assistant is required to protect against injury or damage.
1.Remove the rear kicking plate (LH). Refer to "KICKING PLATE : Removal and Installation Rear Kicking Plate" Removal and Installation - Rear Kicking Plate.





2.Press the headrest holder lock button in on each, then remove headrest LH and headrest RH.
3.Slide the seat to the frontmost position.
4.Remove rear slide covers (LH/RH).
a.Pull up on the rear edge to release pawls.
b.Then slide rearward to remove from seat track.
5.Place the rear cross brace over the track alignment holes, then insert the four LH threaded bolts through the brace into the track and tighten.
6.Slide the seat to rearmost position.
7.Remove front slide covers (LH/RH).
a.Pull up on the front edge to release pawls.
b.Then slide forward to remove from seat track.
8.Disconnect the harness connectors then release from front of seat.
9.Place the front cross brace over the track alignment holes, then insert the two LH threaded bolts through the brace into the track and tighten.
10.Remove the two bolts from the front of the seat track
11.Slide the seat forward, then remove the four rear seat bolts.
12.Fold the seatback down, then remove the seat from the vehicle.
Installation
Installation is in the reverse order of removal.

RH SEAT

Removal

CAUTION:
- Before removal and installation, use shop cloths to protect parts from damage.
- During removal and installation, an assistant is required to protect against injury or damage.
Revision: March 20122013 Infiniti JX
1.Remove the rear kicking plate (LH). Refer to "KICKING PLATE : Removal and Installation Rear Kicking Plate" Removal and Installation - Rear Kicking Plate.





2.Press the headrest holder lock button in, then remove the headrest.
3.Slide the seat to the frontmost position.
4.Remove rear slide covers (LH/RH).
a.Pull up on the rear edge to release pawls.
b.Then slide rearward to remove from seat track.
5.Place the rear cross brace over the track alignment holes, then insert the four LH threaded bolts through the brace into the track and tighten.
6.Slide the seat to rearmost position.
7.Remove front slide covers (LH/RH).
a.Pull up on the front edge to release pawls.
b.Then slide forward to remove from seat track.
8.Disconnect the harness connector then release from front of seat.
9.Place the front cross brace over the track alignment holes, then insert the two LH threaded bolts through the brace into the track and tighten.
10.Remove the two bolts from the front of the seat track.
11.Slide the seat forward, then remove the four rear seat bolts.
12.Fold the seatback down, then remove the seat from the vehicle.
Installation
Installation is in the reverse order of removal.