ICC System Does Not Cancel When CVT Selector Lever Sets On "N"

ICC SYSTEM DOES NOT CANCEL WHEN CVT SELECTOR LEVER SETS ON "N"

Description

The ICC system is not canceled even when the CVT selector lever is shifted to the N position while the ICC
system is active.


Diagnosis Procedure


1. CHECK D RANGE SWITCH

Check if "D RANGE SW" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.
Is the inspection result normal?
YES- GO TO 6.
NO- GO TO 2.

2. PERFORM ALL SELF-DIAGNOSIS ITEMS

1.Perform "All DTC Reading".
2.Check if the "U1000" is detected in "self-diagnosis results" of "ICC/ADAS".
Is "U1000" detected?
YES- GO TO 3.
NO- GO TO 4.

3. CAN COMMUNICATIONS INSPECTION

Check the CAN communication and repair or replace malfunctioning parts. Refer to "ADAS CONTROL UNIT : DTC Logic" Cruise Control.
- INSPECTION END

4. CHECK POSITION SWITCH

Check if "SLCT LVR POSI" operates normally in "DATA MONITOR" of "TRANSMISSION".
Is the inspection result normal?
YES- GO TO 6.
NO- GO TO 5.

5. PERFORM TCM SELF-DIAGNOSIS

1.Perform the "Self Diagnostic Result" of "TRANSMISSION".
2.Repair or replace malfunctioning parts. Refer to "DTC Index" A L L Diagnostic Trouble Codes ( DTC ).
- GO TO 7.

6. REPLACE ADAS CONTROL UNIT

Replace the ADAS control unit. Refer to "Removal and Installation" Removal and Installation.
- GO TO 7.

7. CHECK ICC SYSTEM

1.Erase the self-diagnosis results, and then perform "All DTC Reading" again after performing the action test. (Refer to "Description" Description for action test.)
2.Check that the ICC system is normal.
- INSPECTION END
Revision: March 20122013 Infiniti JX