Removal and Installation

REAR COMBINATION LAMP

Removal and Installation


REAR COMBINATION LAMP

Removal
1.Release metal clip and pawls using a suitable tool and remove rear combination lamp bolt cover.
2.Remove rear combination lamp bolts.
3.Pull rear combination lamp rearward.
4.Disconnect the harness connector from the rear combination lamp and remove rear combination lamp.
Installation
Installation is in the reverse order of removal.

REAR TURN SIGNAL LAMP BULB


WARNING:
To prevent burns, do not touch the glass surface of the bulb with bare hands because the surface is very hot just after the lamp is turned OFF.

CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
- Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc.
may affect the performance of the lamp. When replacing the bulb, be sure to replace it with a new one.
Removal
1.Remove rear combination lamp.
2.Rotate the rear turn signal lamp socket counterclockwise and remove from rear combination lamp.
3.Remove the rear turn signal lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.
Revision: March 20122013 Infiniti JX