Work Procedure

ID REGISTRATION PROCEDURE

Work Procedure

NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs

WITH TRANSMITTER ACTIVATION TOOL

NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II
Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter
Activation Tool J-45295.
With CONSULT.
1.Turn the ignition switch ON.
2.On "WORK SUPPORT" select "ID REGIST."
3.Select Start on "ID REGIST" screen.





4.Place transmitter activation tool (J-45295) (1) against side of tire at location closest to transmitter.
5.Press and hold transmitter activation tool button until indicator lamp turns OFF (approximately 5 seconds).
NOTE:
Perform ID registration procedure starting from front left wheel, then repeat procedure for front right wheel, rear right wheel, and rear left wheel.
6.When ID registration is complete, check the following pattern at each wheel.





7.After the ID registration procedure for all wheels is complete, press "End" to finish ID registration, then check that ID registration for all wheels is complete.

WITHOUT TRANSMITTER ACTIVATION TOOL

NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II
Tool J-50190 before ID registration can be performed.
With CONSULT.
1.Turn the ignition switch ON.
2.On "WORK SUPPORT" select "ID REGIST."
3.Select Start on "ID REGIST" screen.
4.Adjust the tire pressure for all wheels to match the list below.
Revision: March 20122013 Infiniti JX





5.Drive the vehicle at a speed greater than 40 km/h (25 MPH) for 3 minutes or more.
6.After ID registration for all wheels is complete, press "End" to finish ID registration.





7.Adjust the tire pressures for all wheels to the specified value. Refer to "Tire Air Pressure" [1][2]Specifications.
Revision: March 20122013 Infiniti JX