Removal and Installation

REAR BUMPER

Removal and Installation


REMOVAL


CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily substances.
Revision: March 20122013 Infiniti JX
1.Open back door.
2.Remove the rear combination lamps (LH/RH). Refer to "Removal and Installation" Removal and Installation.





3.Remove the rear bumper fascia clips (A) and screws (B) (LH/
RH).
4.Partially remove the rear wheel house protectors. Refer to "REAR WHEEL HOUSE PROTECTOR : Removal and Installation" Removal and Installation.





5.Remove the bumper fascia side upper screws (A) (LH/RH).





6.Remove rear bumper fascia lower side bolts (A) (LH/RH).





7.Remove the rear bumper fascia lower rear clips (A).
8.Disconnect the harness connector from rear sonar sensors.
Revision: March 20122013 Infiniti JX





9.Pull rear bumper fascia downward as shown by the arrows to release from rear bumper side brackets (LH/RH).
: Pawl
10.Remove the rear bumper fascia.

CAUTION:
When removing rear bumper fascia, two people are required to avoid damaging.
11.Remove the following parts after removing rear bumper fascia.
- Rear bumper side brackets (LH/RH)
- Rear bumper fascia reflectors (LH/RH)
- Rear sonar sensors
12.Remove rear bumper energy absorbers 1 and 2.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:





- The following table shows the specified values for checking normal installation status.
- Fitting adjustment cannot be performed.
mm (in)





Revision: March 20122013 Infiniti JX