Removal and Installation

FRONT DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove outside handle and outside handle bracket. Refer to "OUTSIDE HANDLE : Removal and Installation" Service and Repair.





2.Remove door lock assembly TORX bolts (A).
Revision: March 20122013 Infiniti JX
3.Disconnect the harness connector from the front door lock actuator and then remove front door lock assembly.





4.Remove door key cylinder rod (1) from door lock assembly (2)
for LH front door only.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Do not reuse door lock assembly TORX bolts. Always replace bolts with new ones when removed.
- Check door lock cables are properly engaged to inside handle and outside handle bracket.
- When installing door key cylinder rod on the LH front door, be sure to rotate door key cylinder rod holder until a click is felt.
- After installation, check door open/close, lock/unlock operation.
- Check door lock assembly for poor lubrication. If necessary apply a suitable multi-purpose grease.