Obtain A/V Unit Part Number (Optional)

Obtain A/V Unit Part Number (OPTIONAL)

1. Make sure the shift selector is in Park (A/T) or Neutral (M/T), and the parking brake is set.

2. Connect the plus VI to the vehicle.

3. Turn the ignition ON.

NOTE:
You may want to start the engine to keep the battery charged during this procedure.





4. Write down customers radio station presets (presets will be lost during this procedure).

5. Open/start ASIST on the CONSULT PC, and then select CONSULT III plus.

6. Wait for the plus VI to be detected, and the status box(es) to turn "green".





7. Select the plus VI with the correct serial number being used (if more than one in the shop) by highlighting it in the Connection Status box.

8. Select Re/programming Configuration.





9. Use arrows (if needed) to view and read all Cautions.

10. Check the box confirming the precautions have been read.

11. Select Next.





12. Select the Automatic Selection (VIN) tab.





13. Select Confirm.

^ Wait while system call completes.





14. Select Confirm.





15. Select Multi A/V.





16. Select Read / Write Configuration.





17. Select Before Replace ECU.





18. Select Save.





^ The software P/N is shown in Figure 10. Ignore it.

19. Select End

NOTE:
Leave C-III plus running and the plus VI connected.

20. Turn OFF the audio system.

21. Put the A/V system into System Diagnostic Mode as follows:





a. Press and hold the SETTING button.

b. While holding the SETTING button, turn the volume control knob 40 clicks or more.

^ The volume control knob can be turned either direction.





^ When the system goes into the System Diagnostic Menu, the screen in Figure 12 will display.

22. Select Confirmation/Adjustment.





23. Select Delete Unit Connection Log.





24. Select Yes.





25. Select Initialize Settings.





26. Select Accessory Number Initialization.





27. Select Yes.

28. Wait while the system "initializes".





^ The screen in Figure 18 will display while "initializing".





^ The screen in Figure 19 will display when "initialization" is complete.

29. Once "initialization" is complete, reboot the Multi A/V system as follows:

a. Turn OFF the ignition.

b. Wait 10 seconds.

c. Turn ON the ignition.





30. Select Diagnosis (One System).





31. Select MULTI AV.





32. Select the ECU identification tab.

33. Print or write down the ECU PART NUMBER for ordering and warranty information:

25915-_ _ _ _ _

34. Select Home.

The A/V unit can now be ordered with this part number. The current A/V unit can now be configured for use until it is replaced.