Line Pressure Test

LINE PRESSURE TEST

Work Procedure

1.Check the amount of engine oil. Replenish if necessary. Refer to "Inspection" Procedures.
2.Check for leak of the CVT fluid. Refer to "Inspection" Inspection.
3.Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80�C (122 to
176�F).





4.After warming up transaxle assembly, remove oil pressure detection plug (A) and install oil pressure gauge [special service tool: - (OTC3492)].
NOTE:
When using oil pressure gauge, be sure to use O-ring attached to oil pressure detection plug.
5.Be sure to apply the parking brake and block the tires.
6.Start the engine.
7.Measure the line pressure at both idle and the stall speed.

CAUTION:
Keep brake pedal pressed all the way down during measurement.


Line pressure: "Line Pressure" Pressure, Vacuum and Temperature Specifications
8.Install O-ring to fluid pressure detection plug after the measurements are complete.

CAUTION:
- Never reuse O-ring.
- Apply CVT fluid to O-ring.
9.Install oil pressure detection plug and tighten to the specified torque.





RESULT OF INSPECTION





Revision: March 20122013 Infiniti JX

Revision: March 20122013 Infiniti JX