B2456

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. SELF-DIAGNOSIS WITH PRE-CRASH SEAT BELT CONTROL UNIT

1.Turn ignition switch ON.
2.Check "Self-diagnostic result" with CONSULT.
Is DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK FUSE AND FUSIBLE LINK

1.Turn ignition switch OFF.
2.Check 30 A fuse (No.77).
Is the inspection result normal?
YES- GO TO 2.
NO- Replace the blown fuse after repairing the affected circuit if a fuse is blown.

2. CHECK PRE-CRASH SEAT BELT MOTOR POWER SUPPLY

1.Disconnect pre-crash seat belt control unit (passenger side) harness connector.
2.Check voltage between pre-crash seat belt control unit (passenger side) harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness between pre-crash seat belt control unit (passenger side) and fuse.

3. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END