B2582

B2581, B2582 INTAKE SENSOR

DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC68, "DTC Logic".
- If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. "DTC Logic" Control Unit.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Turn ignition switch ON.
2.Select "Self Diagnostic Result" mode of "HVAC" using CONSULT.
3.Check DTC.
Is DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK INTAKE SENSOR POWER SUPPLY

1.Turn ignition switch OFF.
2.Disconnect intake sensor connector.
3.Turn ignition switch ON.
4.Check voltage between intake sensor harness connector and ground.





Is the inspection result normal?
YES- GO TO 2.
NO- GO TO 4.

2. CHECK INTAKE SENSOR GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Check continuity between intake sensor harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair harness or connector.

3. CHECK INTAKE SENSOR

Check intake sensor. Refer to "Component Inspection" .
Is the inspection result normal?
YES- Replace A/C auto amp. Refer to "Removal and Installation" Service and Repair.
NO- Replace intake sensor. Refer to "Removal and Installation" Removal and Installation.

4. CHECK INTAKE SENSOR POWER SUPPLY CIRCUIT FOR OPEN

1.Turn ignition switch OFF.
2.Disconnect A/C auto amp. connector.
3.Check continuity between intake sensor harness connector and A/C auto amp. harness connector.





Is the inspection result normal?
YES- GO TO 5.
NO- Repair harness or connector.

5. CHECK INTAKE SENSOR POWER SUPPLY CIRCUIT FOR GROUND SHORT

Check continuity between intake sensor harness connector and ground.





Is the inspection result normal?
YES- GO TO 6.
NO- Repair harness or connector.

6. CHECK INTAKE SENSOR POWER SUPPLY CIRCUIT FOR POWER SHORT

1.Turn ignition switch ON.
2.Check voltage between intake sensor harness connector and ground.





Is the inspection result normal?
YES- Replace A/C auto amp. Refer to "Removal and Installation" Service and Repair.
NO- Repair harness or connector.


Component Inspection


1. CHECK INTAKE SENSOR

1.Turn ignition switch OFF.
2.Disconnect intake sensor connector.
3.Check resistance between intake sensor terminals.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace intake sensor. Refer to "Removal and Installation" Removal and Installation.