P1807

P1807 OUT PUT SHAFT SPEED SENSOR

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
2.Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "P1807" detected?
YES- Proceed to diagnosis procedure. Refer to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM TCM SELF-DIAGNOSIS

With CONSULT
Perform self-diagnosis for "TRANSMISSION".
Is any DTCs detected?
YES- Check the DTC. Refer to "DTC Index" Testing and Inspection.
NO- GO TO 2.

2. CHECK TERMINALS AND HARNESS CONNECTORS

Check transfer control unit pin terminals for damage or loose connection with harness connector.
Is inspection result normal?
YES- After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC
"P1807" is detected, Replace transfer control unit. Refer to "Removal and Installation" Service and Repair.
NO- Repair or replace error-detected parts.