P180E

P180E SENSOR POWER SUPPLY (8V)

Description

Supplies power (8V) to transfer internal speed sensor.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Turn the ignition switch ON.
2.Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "P180E" detected?
YES- Proceed to diagnosis procedure. Refer to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK TRANSFER INTERNAL SPEED SENSOR POWER SUPPLY (1)

1.Turn the ignition switch OFF.
2.Disconnect transfer control actuator harness connector.
3.Turn the ignition switch ON.

CAUTION:
Never start the engine.
4.Check the voltage between transfer control actuator harness connector terminals.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK TRANSFER INTERNAL SPEED SENSOR CIRCUIT

1.Turn the ignition switch OFF.
2.Disconnect transfer control unit harness connector.
3.Check the continuity between transfer control unit harness connector and transfer control actuator harness connector.





4.Check the continuity between transfer control actuator harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace error-detected parts.

3. CHECK TRANSFER INTERNAL SPEED SENSOR POWER SUPPLY (2)

1.Turn the ignition switch OFF.
2.Connect transfer control actuator harness connector.
3.Turn the ignition switch ON.

CAUTION:
Never start the engine.
4.Check the voltage between transfer control actuator harness connector terminals.





Is the inspection result normal?
YES- GO TO 4.
NO- Transfer internal speed sensor is malfunctioning. Replace transfer control actuator. Refer to DLN112, "Removal and Installation".

4. CHECK TERMINALS AND HARNESS CONNECTORS

Check the pin terminals for damage or loose connection with each harness connector.
Is the inspection result normal?
YES- Replace transfer control unit. Refer to "Removal and Installation" Service and Repair.
NO- Repair or replace error-detected parts.