Work Procedure (Camera Aiming Adjustment)

CAMERA AIMING ADJUSTMENT

Work Procedure (Camera Aiming Adjustment)


CAUTION:
Perform the adjustment under unloaded vehicle condition.

1. CHECK VEHICLE HEIGHT






Measure the wheelarch height. Calculate "Dh".





NOTE:
"Dh" may be calculated as a minus value.
- GO TO 2.

2. CAMERA AIMING ADJUSTMENT


CAUTION:
Operate CONSULT outside the vehicle, and close all the doors. (To retain vehicle attitude appropriately)
1.Select "Work Support" on "LANE CAMERA" with CONSULT.
2.Select "AUTO AIM".
3.Confirm the following items;
-The target should be accurately placed.
-The vehicle should be stopped.
4.Select "Start" to perform camera aiming.

CAUTION:
- Never select "Start" when the target is not accurately placed.
- Wait 5 seconds or more after selecting "Start".
5. Input "Dh", and then select "Start".

CAUTION:
Never change "Ht" and "Dt".
6.Confirm the displayed item.
-"Normally Completed": Select "Completion".
-"SUSPENSION", "X AIMING NG Y", "ABNORMALLY COMPLETED": Perform the following services.





NOTE:
Replace camera unit if "00H Routine not activated" or "10H Writing error" are repeatedly indicated during the above two services are performed.
7.Confirm that "Normally Completed" is displayed and then select "End" to close the aiming adjustment procedure.
- GO TO 3.

3. PERFORM SELF-DIAGNOSIS

Perform self-diagnosis of lane camera unit with CONSULT.
Is any DTC detected?
YES- Perform diagnosis on the detected DTC and repair or replace the applicable item. Refer to DAS293, "DTC Index".
NO- GO TO 4.

4. ACTION TEST

Test the LDW/LDP system operation by action test. Refer to "Description" LDW & LDP.
- WORK END