Sliding Switch

SLIDING SWITCH

Component Function Check


1. CHECK FUNCTION

1.Select "SLIDE SW-FR", "SLIDE SW-RR" in "Data monitor" mode using CONSULT.
2.Check sliding switch signal under the following conditions.





Is the indication normal?
YES- INSPECTION END
NO- Perform diagnosis procedure. Refer to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK SLIDING SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect power seat switch connector.
3.Turn ignition switch ON.
4.Check voltage between power seat switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK SLIDING SWITCH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect driver seat control unit connector.
3.Check continuity between driver seat control unit harness connector and power seat switch harness connector.





4.Check continuity between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES- Replace driver seat control unit.
NO- Repair or replace harness or connector.

3. CHECK SLIDING SWITCH

Refer to "Component Inspection" .
Is the inspection result normal?
YES- GO TO 4.
NO- Replace power seat switch.

4. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END


Component Inspection


1. CHECK SLIDING SWITCH

1.Turn ignition switch OFF.
2.Disconnect power seat switch (sliding switch) connector.
3.Check continuity between power seat switch (sliding switch) terminals.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace power seat switch.