ASCD Brake Switch

ASCD BRAKE SWITCH

Component Function Check


1. CHECK ASCD BRAKE SWITCH FUNCTION

WITH CONSULT
1.Turn ignition switch ON.
2.Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
3.Check "BRAKE SW1" indication under the following conditions.





WITHOUT CONSULT
1.Turn ignition switch ON.
2.Check the voltage between ECM harness connector terminals as per the following.





Is the inspection result normal?
YES- INSPECTION END
NO- Go to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK ASCD BRAKE SWITCH POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ASCD brake switch harness connector.
3.Turn ignition switch ON.
4.Check the voltage between ASCD brake switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. DETECT MALFUNCTIONING PART

Check the following.
- 10 A fuse (No. 3)
- Harness for open or short between ASCD brake switch and fuse
- Loose or poor connection for each connector and harness
- Repair open circuit or short to ground in harness or connectors.

3. CHECK ASCD BRAKE SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between ASCD brake switch harness connector and ECM harness connector.





4.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 5.
NO- GO TO 4.

4. DETECT MALFUNCTIONING PART

Check the following.
- Harness for open or short between ECM and ASCD brake switch
- Loose or poor connection for each connector and harness
- Repair open circuit, short to ground or short to power in harness or connectors.

5. CHECK ASCD BRAKE SWITCH

Refer to "Component Inspection (ASCD Brake Switch)" .
Is the inspection result normal?
YES- GO TO 6.
NO- Replace ASCD brake switch. Refer to "Removal and Installation" Removal and Installation.

6. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END


Component Inspection (ASCD Brake Switch)


1. CHECK ASCD BRAKE SWITCH-I

1.Turn ignition switch OFF.
2.Disconnect ASCD brake switch harness connector.
3.Check the continuity between ASCD brake switch terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 2.

2. CHECK ASCD BRAKE SWITCH-II

1.Adjust ASCD brake switch installation. Refer to "Inspection and Adjustment" Adjustments.
2.Check the continuity between ASCD brake switch terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace ASCD brake switch. Refer to "Removal and Installation" Removal and Installation.