Inspection Procedure

LARGE ROLL ANGLE

Inspection Procedure


1. CHECK APPEARANCE

1.Visually check that the exterior parts (e.g. suspension spring) have no malfunctions.
2.Visually check tube and pipe for crush or oil leakage.
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace damaged parts.

2. CHECK NEEDLE VALVE OF PPMU






Check that needle valves A and C are tightened to the specified torque.





Is the inspection result normal?
YES- GO TO 3.
NO- Tighten to the specified torque.

3. SYSTEM PRESSURE CHECK

Check system pressure. Refer to "Work Procedure" Check System Pressure.
Is the inspection result normal?
YES- GO TO 4.
NO- Perform adjustment of system pressure. Refer to "Work Procedure" Air Bleeding Method.

4. CHECK INTERNAL LEAKAGE

Check internal leakage. Refer to "Work Procedure" Check Internal Leakage.
Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 5.

5. CHECK MALFUNCTIONING PART

Identify malfunctioning part. Refer to "Work Procedure" Check For Malfunction.
Does the pressure increase?
YES- Replace the PPMU. Refer to "PPMU, MIDDLE TUBE ASSEMBLY, PPMU PIPE : Removal and Installation" Removal and Installation.
NO- GO TO 6.

6. CHECK SHOCK ABSORBER

Identify malfunctioning shock absorber. Refer to "Work Procedure" Check Shock Absorber For Malfunction.
- Replace identified shock absorber. Refer to "Removal and Installation" Removal and Installation (front), "Removal and Installation" Removal and Installation (rear).