Operation CHARM: Car repair manuals for everyone.

Work Procedure




TRANSFER LOCK POSITION SENSOR LEARNING

Work Procedure

NOTE:
In fail-safe mode, can not perform work support. (Except that DTC P181F or P182B is detected.)

1. PREPARATION BEFORE WORK

With CONSULT
1.Continue the following condition at vehicle.






CAUTION:
Never drive the vehicle.
2.Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT
"DATA MONITOR" for "ALL MODE AWD/4WD".
3.Continue the following condition.





- GO TO 2.

2. PERFORM LOCK POSITION SENOR LEARNING

With CONSULT
1.Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/
4WD".
2.Select "Start".
3.Wait until the motor operation stop.
Is "Error" detected?
YES (within 5 times)-GO TO 1.
YES (over 5 times)-Transfer assembly is mechanical malfunction. Replace transfer assembly. Refer to
"Removal and Installation" Removal and Installation.
NO- GO TO 3.

3. PERFORM SELF-DIAGNOSIS

With CONSULT
1.Erase self-diagnosis result for "ALL MODE AWD/4WD".
2.Turn the ignition switch ON to OFF.

CAUTION:
Wait for 10 seconds after turning ignition switch OFF.
3.Start the engine.

CAUTION:
Never drive the vehicle.
4.Perform self-diagnosis for "ALL MODE AWD/4WD".
Is "DTC P182B" detected?
YES- GO TO 1.
NO- WORK END