Special Repair Requirement

INSPECTION AND ADJUSTMENT

MEMORY STORING : Special Repair Requirement


Memory Storage Procedure

Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by following procedure.

1. STEP 1

Check the following conditions.
- Ignition switch: ON
- A/T shift selector: P position
- GO TO 2.

2. STEP 2

Adjust driver seat, steering column and outside mirror position manually.
- GO TO 3.

3. STEP 3

1.Push set switch.
NOTE:
- Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
- Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 second.
2.Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
NOTE:
- To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
- To modify driver seat positions, memory indicator will be turned OFF for 0.5 second, then turned ON for
5 seconds.
NOTE:
If memory is stored in the same memory switch, the previous memory will be deleted.
- GO TO 4.

4. STEP 4

Confirm the operation of each part with memory operation.
- END