Front Seat

FRONT SEAT

SEATBACK : Disassembly and Assembly


DISASSEMBLY

1.Remove the seatback board.





1.Remove the screws (A) on lower side of the seatback board.
2.Disengage the clips on lower side, pull the seatback board toward vehicle rear, and disengage the pawls on lateral side.
3.Pull the back board downward, disengage the pawls on upper side, and remove the seatback board.






CAUTION:
Always use a remover tool when removing clip. Or otherwise surface of trim may be damaged.
2.Remove the headrest (with headrest display only).





1.Disconnect the headrest display harness connector (A) and the harness clamps (B).





2.Pull out clip (A) of headrest display harness and upper tube (1)





3.Raise the headrest to the top position.





4.Disengage the escutcheon (1) of the headrest display harness and upper tube as shown in the figure using remover tool (A).










3.Remove the headrest holder from the seatback while pressing the pawls as shown by the arrows in the figure.

CAUTION:
Before installing headrest holder check its orientation (Front/rear and right/left).





4.Disconnect the seatback heater unit harness connector (A).
(with heater seat model only)
5.Remove the seatback pad and seatback trim.
1.Disconnect the foot welcome lamp harness connector and the harness clamp.
2.Remove the seatback retainer on the back side of the seatback.
3.Remove the side air bag harness clamp.
4.Remove the side air bag module mounting nuts.





5.Remove the headrest display harness lower tube (1) from the seat frame assembly (2) while pressing up the pawls as shown by the arrows in the figure.
6.Remove the seatback trim and the seatback pad from the seat frame assembly. Remove them together with the headrest display harness lower tube and the side air bag module.
7.Remove the hog rings, and separate the seatback trim and seatback pad.
6.Remove the seatback silencer.
7.Remove the following parts after removing seatback silencer.
- Seatback climate controlled seat unit (with climate controlled seat model only).
Refer to "CLIMATE CONTROLLED SEAT UNIT : Disassembly and Assembly" Front Seat.
- Remove the lumber support unit assembly.

ASSEMBLY

Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seatback trim in position, and then securely connect the trim or trim cord with the pad side wire.