ID Registration

ID REGISTRATION

Work Procedure


1. TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE


CAUTION:
To perform ID registration, observe the following points:
- Never register ID in a place where radio waves are interfered (e.g. radio tower).
- Never register ID in a place close to vehicles including TPMS.
With CONSULT
1.Turn the ignition switch ON.
2.Display the "WORK SUPPORT" screen for "AIR PRESSURE MONITOR" and select "ID REGIST".





3.Press the activation tool (J-45295) (1) against the side of the tire at the location closest to the tire pressure sensor.
4.Wait until the indicator lamp turns OFF (approximately 5 seconds).

CAUTION:
Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
5.When ID registration is completed, check the following pattern at each wheel.





6.After the ID registration procedure for all wheels is completed, press "End" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES- ID registration END.
NO- Refer to "Diagnosis Procedure" ID Registration Cannot Be Completed.