Turn Signal - Continues Flashing After Turns
BULLETIN NUMBER ISSUE DATE GROUPSB87-10-001 June 12, 1987 STEERING
P'UP (KB) AND TROOPER II (KT) TURN SIGNAL SWITCH FAILURE TO CANCEL
VEHICLES AFFECTED
All P'UP (KB) models; Trooper II (KT) models before VIN H0731925 OR H5713840.
SERVICE INFORMATION
On affected models, the turn signal cancelling pins on the steering wheel may fail to catch on the combination switch ramps, allowing the turn signal lights to continue to flash following a turn. Installation of the spring and pin assembly described in this Service Bulletin will ensure that the turn signals self-cancel.
SERVICE PROCEDURE
1. Remove the steering wheel as described in the appropriate Workshop Manual.
2. Check the operation of the combination switch and repair or replace if necessary.
Figure 1 - Steering Wheel Pins:
3. Install one of the new spring and pin assemblies (part No. 8-94472-575-0) on each of the steering wheel's pins (Figure 1).
4. Install the steering wheel and check for proper operation of the turn signal system.
PARTS INFORMATION
Each vehicle requires two of the following parts:
Part No. Description
8-94472-575-0 Spring and Pin Assy.
FLAT RATE MANUAL UPDATE INFORMATION
OPER. OPERATION TASK SPEC. P'UP TROOPER
NUMBER INSTR. TROOPER II
100199 TURN SIGNAL CANCEL PIN Install .4 .4
MODIFICATION
Trouble Code 71