Cruise Control Switch - Inoperative

BULLETIN NUMBER
SB92-04-009



ISSUE DATE
July 30, 1992



GROUP
ELECTRICAL



RODEO (UC), TROOPER II (KT) AND PICKUP (TF) CRUISE CONTROL SWITCH INOPERATIVE (This Service Bulletin supercedes SB91-04-009, to correct detent pin and spring location.)



AFFECTED VEHICLES

1988-91 Rodeo (UC), Trooper II (KT) and Pickup (TF) models equipped with cruise control.

SERVICE INFORMATION

On affected vehicles, the cruise control switch detent pins may become worn, causing the switch to become inoperative. Replacing the detent pins will restore cruise control switch operation. For case of repair, a cruise control switch repair kit (see "Parts Information" section of this Service Bulletin) provides new components for the cruise control switch. All of the repair kit components should be installed, to ensure proper cruise control switch operation.

This Service Bulletin contains the procedure for installing the new cruise control switch components provided in the repair kit.

SERVICE PROCEDURE





Refer to Figure 1.

1. Be sure the ignition switch is in the "OFF" position.

2. Remove existing cruise control switch components as follows:

NOTE
Use a miniature pick or other small suitable tool for removal of components.



a. Insert the pick between the cruise control button and knob. Push in one of the two button legs to remove the button. Remove and discard the button, contact plate (may remain inside button), and set spring.

b. Pry the ring away from the center shaft. Remove and discard the ring, plate (may remain inside knob) and knob.

c. Push the shaft pin out, and slide the cam off the shaft. Discard shaft pin only. Keep cam for reassembly.

d. Remove and discard the two plastic detent pins and the two springs. Do not remove the switch plate.

3. Install the cruise control repair kit components as follows:

a. Install two new springs and plastic detent pins.

b. Reinstall the cam, using the new shaft pin.

c. Install the new plate and knob. Be sure the yellow mark shows in the "window" on the shaft.

d. Install the new ring, using a 1/4" drive socket to seat the ring.

e. Install the new set spring, contact plate and button.

4. Test drive vehicle to ensure proper cruise control operation.



PARTS INFORMATION


Part No. Description

8-97063-947-0 Cruise Control Switch Repair Kit


FLAT RATE MANUAL UPDATE INFORMATION


OPERATION
OPERATION NUMBER TASK TIME

Cruise Control Switch Repair Kit 042171 Install 0.5