Counter Shaft

DISASSEMBLY

1. Counter shaft front bearing outer race and O-ring




- Using a hydraulic press and bearing race receiver and case support, remove the counter shaft front bearing outer race.
Bearing race receiver & case support: J-37358
- Remove the O-ring.

2. Counter shaft front bearing




- Remove the front bearing assembly from the counter shaft. Use a hydraulic press, remover and puller plate.
Counter shaft front bearing remover: J-37359
Bearing and gear puller: J-22912-01

3. Counter shaft

REASSEMBLY

To reassemble, follow the disassembly steps in the reverse order, noting the following points:

3. Counter shaft

2. Counter shaft front bearing




- Install the counter shaft front bearing assembly onto the counter shaft, using a hydraulic press, installer and puller plate.
Installer: J-37357
Bearing and gear puller: J-22912-01

1. Counter shaft front bearing outer race and O-ring




- Install a new O-ring on the counter shaft outer race and lubricate it.
- Using installer and driver handle, lightly tap the race into its bore until the O-ring is compressed.




- Using a hydraulic press, installer and driver handle, install the race until its shoulder rests on the inside of the case.
Installer: J-37357
Driver handle: J-8092