Engine Control Module (ECM)

ECM:

REMOVAL
- Negative battery cable
- Lower trim panel at console (4 fasteners)
- Air Conditioning Heater transfer tube
- ABS controller electrical connector (1) (if equipt)
- ABS controller (4 fasteners) (if equipt)
- Four (4) fasteners for ECM bracket
- ECM electrical connectors (2)
- ECM from 'inder dash, bracket still attached


NOTE: To prevent possible Electronic Discharge damage to the ECM, Do not touch the connector pins or soldered components on the circuit board.


INSTALLATION
- ECM and bracket under dash
- Four (4) fasteners and tighten
- Two (2) ECM electrical connectors
- ABS controller and four (4) fasteners (if equipt)
- ABS controller electrical connector (if equipt)
- Air Conditioning Heater transfer tube
- Lower trim panel at console (4 fasteners)
- Negative battery cable