Removal

REMOVAL
Preparation:
Disconnect battery ground cable.
Remove engine hood.
In order to return the hood to the original position exactly, make alignment on the hood and hinges before removal.
Drain radiator coolant.
1. Accelerator cable
- Disconnect from throttle valve and common chamber.
2. Ventilation hose
3. Air hose
4. Air cleaner assembly
5. Canister vacuum hose
. Vacuum booster hose
7. Engine harness connectors
- Disconnect three connectors on canister side.
8. Battery ground cable
- Disconnect two black and white connector clips from the power steering pump bracket.
9. Ground cables
- Disconnect two terminals connected to the battery support and the front right frame.
10. Bonding cable connector
- Disconnect connector on the left side dash panel.
11. Bonding cable terminal
- Disconnect terminal on the back of left bank.
12. Starter harness connector
Disconnect from starter.
13. Radiator
- Disconnect upper and lower hoses from the engine.
- Disconnect coolant reserve tank hose from radiator.
- Disconnect ATF hose from the pipe. (A/T)
- Remove radiator lower hose clip from the hose bracket.
- Remove radiator lower fan shroud.
- Remove radiator.
14. Power steering pump drive belt
15. Power steering pump
- Remove two bolts on the bracket, and place the pump along with piping on the body side.
16. A/C compressor drive belt
17. A/C compressor
- Remove fixing bolts and shift aside the compressor with piping attached.
18. Heater hoses
- Disconnect two hoses from the engine.
19. ATF pipes
- Disconnect two pipes from right side engine mount.
20. Transmission assembly
- Transmission and Drivetrain
21. Left side engine mount
- Support the engine.
- Remove two fixing bolts from engine mount on chassis side.
22. Right side engine mount
- Remove two fixing bolts from engine mount on chassis side.
23. Engine assembly