Crankshaft Position Sensor: Service and Repair
REMOVE1. Disconnect battery ground cable.
Protection Shield:
2. Remove exhaust and transfer protector.
3. Disconnect front propeller shaft joint.
Crank Angle Sensor / Crankshaft Position Sensor:
4. Disconnect wiring connector at crank angle sensor.
5. Remove mounting nut and remove sensor.
REFIT
1. Lubricate O-ring on new sensor and fit to engine block.
2. Fit sensor mounting bolt and tighten to:
87 in lb (10 Nm)
3. Reconnect front propeller shaft joint and tighten to:
46 ft lb (63 Nm)
4. Refit protection shield and tighten bolts to:
27 ft lb (37 Nm)
5. Reconnect battery cable.