Unit Repair

DISASSEMBLY
1. Distributor cap
2. Distributor rotor
3. Housing gasket
4. Dust bushing
5. Roll pin
6. Pinion gear and gasket
7. Distributor housing

REASSEMBLY
1. Distributor housing
2. Pinion gear and gasket
3. Roll pin
4. Dust bushing
5. Housing gasket
6. Distributor rotor
7. Distributor cap

INSPECTION AND REPAIR
Make necessary correction or replace parts if wear, damage or any other abnormal conditions are found through inspection.





Distributor cap
- Inspect the distributor cap for cracking, burning, corrosion and wear.
(1) Electrode (cable side)
(2) Side electrodes
(3) Center contact carbon point
(4) Rotor assembly





Cleaning the rotor plate
- Take out two screws fixing the rotor plate cover, then remove it. Using a soft brush, clean the rotor plate in the angle signal port area and blow away any foreign particles.

NOTE:
- The distributor body assembly is of an integral design and cannot be disassembled.
The entire distributor assembly must be replaced if service becomes necessary.