Removal and Installation

REMOVAL
Preparation: Disconnect Battery Ground Cable.

Distributor:

1. Disconnect Distributor Wiring Connector.
2. Disconnect High Tension Cables (Spark Plug Wires).
3. Remove Distributor Fixing Bolt.
4. Remove Distributor Assembly.


INSTALLATION
To install, follow the removal steps in the reverse order.

4. Install Distributor Assembly.
- Remove Cylinder Head Cover.
- Move the No. 4 Cylinder to TDC on the Compression Stroke.
- Align the Camshaft Pulley setting mark with the Front Plate setting mark.
- Apply Engine Oil to the Distributor O-Ring.
- Align the Distributor Case setting mark with the Distributor Shaft setting mark.




- Install the Distributor to the Cylinder Head. Align the Distributor Shaft setting mark with the Cylinder Head setting mark.
- Install the Cylinder Head Cover.

3. Install Distributor Fixing Bolt and tighten to the specified torque.

Torque: 19 N.m (14 lb.ft)

2. Connect High Tension Cables (Spark Plug Wires).
1. Connect Distributor Wiring Connector.

Set the Ignition Timing.