95 1/2 Model

NOTE: If you clear the Diagnosis Trouble Codes (DTCs) you will not be able to read any codes recorded during the last trouble. To be able to use the DTC again to identify a problem you will need to reproduce the fault or the problem. This may require a new test drive or just turn the Ignition "ON" (this depends on the nature of the fault).





1. Short the Diagnosis Connector B-67 Terminal 1 to Terminal 2 (ground).
- IF it is flashing and the flash is 0.4 seconds "ON" and 0.4 second "OFF" without interruption, this means that there is no DTC. The DTCs are already cleared.

2. IF a code is flashed, wait until the lamp is flashing.
3. Push "Power Switch" then "Winter Switch" (do this within 3 seconds).
- If you continue to have malfunctions: This means that the problem is still there or that the recovery was not done, refer to DTC Check.

4. If you can not clear the DTC:
- Refer to Transmission Control Module (TCM) Precautions. Service Precautions
- Disconnect the TCM.
- Reconnect the TCM.
- If the DTC is not cleared, refer to TCM MEM-CAL Replacement. Service and Repair