Reverse Clutch Piston and Center Support

REVERSE CLUTCH PISTON AND CENTER SUPPORT
DISASSEMBLY
1. Retaining ring (Fig. 7A-85)
^ Install the tool on spring seat.
^ Compress the spring seat. Compressor: J-23327

NOTE: Do not over-stress the springs and seat, as this will cause damage to the spring seat.






2. Spring seat
3. Springs
4. Piston
5. Center support
^ Remove 8 bolts from center support. Remove center support from adapter case.
6. Gasket
7. Transfer plate
8. Gasket
9. Restrictor
10. Retainer plate
11. Plug
12. Spring
13. Overrun lock out valve

INSPECTION AND REPAIR
Visual check
^ If any damage, deformation or local wear is found in a retaining ring, return spring, spring retainer, piston or center support, replace it.

REASSEMBLY
13. Overrun lock out valve
12. Spring
^ Install overrun lock out valve and spring.

NOTE: Ensure correct assembly of valve. The spring should be located over the long small diameter end.

11. Plug
10. Pin
9. Restrictor (Fig. 7A-86)
^ Place in the lube overdrive channel in the adapter case housing.






8. Gasket
7. Transfer plate
6. Gasket
5. Center support
^ Install center support with 8 bolts.
Torque: N.m (lb.ft) 25 (18)
4. Piston
3. Springs
2. Spring seat
1. Retaining ring
^ Install twenty four springs, spring seat and retaining ring.
^ Install the tool.
^ Compress retaining ring and springs.
^ Seat snap ring in groove. Compressor: J-23327