Rear Wheel Antilock Brakes
The Rear Wheel Anti-lock (RWAL) brake system is designed to prevent the rear wheels from locking up and to assist directional stability when the brakes are applied.The RWAL brake controller determines if rear wheel anti-lock brake operation is required by monitoring the stop light switch (without cruise control) or brake switch (with cruise control) state and the speed signal generated by the differential speed sensor. The differential speed sensor is a magnetic pickup coil which generates an AC voltage as a toothed exciter ring passes it. The frequency of the generated signal is proportional to vehicle speed.
When the controller detects an impending lockup, it will energize and deenergize the isolation solenoid and dump solenoid to prevent lockup. Energizing the isolation solenoid isolates the rear brake hydraulic circuits from the master cylinder. This allows brake pressure to be maintained but prevents brake pressure from increasing. Energizing the dump solenoid reduces the rear brake hydraulic pressure by opening a valve which allows brake fluid to flow into an accumulator. The controller energizes the solenoids by applying voltage.
The controller has the capability to detect a fault and set a code. When the controller detects a fault, it will turn ON the "Rr. ABS" brake warning light and the "BRAKE" warning light by grounding the lamps at terminals 2 and 5. To read the codes, ground the diagnostic test connector. The "Rr. ABS" and "BRAKE" warning lamps will flash indicating the code number. The "BRAKE" warning light will stay ON if the parking brake is ON or unequal brake fluid pressure is detected.
When the 4WD is engaged, the RWAL brake system will be disabled. The controller is able to determine that the 4WD is engaged whenever the 4WD indicator switch closes and grounds terminal 3 of the rear wheel anti-lock brake controller.