Crankshaft Position Sensor: Service and Repair

Protection Shield:

Crank Angle Sensor / Crankshaft Position Sensor:

REMOVE
1. Disconnect battery ground cable.
2. Remove exhaust and transfer protector.
3. Disconnect front propeller shaft joint.
4. Disconnect wiring connector at crank angle sensor.
5. Remove mounting nut and remove sensor.

INSTALL
1. Lubricate O-ring on new sensor and fit to engine block.
2. Fit sensor mounting bolt

Tighten
Bolt to 10 Nm (87 in lb).

3. Reconnect front propeller shaft joint

Tighten
Bolt to 63 Nm (46 ft lb).

4. Refit protection shield

Tighten
Bolt to 37 Nm (27 ft lb).

5. Reconnect battery cable.